Table of Contents
Advertisement
To change the priority order of access points within a
group, scroll to an access point, and select
Organise
Change
>
Packet data access points
Select
Menu
Ctrl. panel
>
Connection
Destinations
>
follow the instructions on the display. Or, open one of
the access point groups, select an access point marked
with
, and select Edit.
Use the instructions provided by your service provider
to edit the following:
Access point name
•
provided by your service provider.
User name
— The user name may be needed to
•
make a data connection, and is usually provided by
your service provider.
Prompt password
•
to ask for a password every time you log in to a
server, or if you do not want to save your password
in the device, select Yes.
Password
— A password may be needed to make
•
a data connection and is usually provided by your
service provider.
Authentication
•
your password encrypted or
password encrypted when possible.
Homepage
— Depending on the access point type
•
you are setting up, enter the web address or the
address of the multimedia message centre.
Use access point
•
set the device to ask for confirmation before the
142
connection using this access point is created, or
Options
priority.
Settings
and
>
Access
point, and
>
— The access point name is
— If you want to set the device
— Select
Secure
to always send
Normal
to send your
— Select
After confirmation
Automatically
to set the device to connect to the
destination using this access point automatically.
>
Select
Options
Advanced settings
>
following:
Network type
•
to transfer data to and from your device. The other
settings depend on the selected network type.
Phone IP address
•
address of your device.
DNS addresses
•
primary and secondary DNS servers, if required by
your service provider. To obtain these addresses,
contact your internet service provider.
Proxy server address
•
proxy server.
Proxy port number
•
the proxy server.
WLAN internet access points
Select
Menu
Ctrl. panel
>
Connection
Destinations
>
follow the instructions on the display. Or, open one of
the access point groups, select an access point marked
with
, and select Edit.
Use the instructions provided by your service provider
to edit the following:
WLAN network name
•
Search for
networks. If you select an existing
network,
WLAN network mode
security mode
are determined by the settings of its
to
access point device.
Network status
•
name is displayed.
and from the
— Select the internet protocol type
(for IPv4 only) — Enter the IP
— Enter the IP addresses of the
— Enter the address of the
— Enter the port number of
Settings
and
>
Access
point, and
>
— Select
Enter manually
and
WLAN
— Define whether the network
or
Advertisement
Table of Contents
