Table of Contents
Advertisement
6 Installation
6.1 Electrical connection
Power voltage
Danger of electrocution
• The appliance must be connected to
ground in compliance with electrical
system safety standards.
• Do not pull the cable to remove the
plug.
General information
• Check the mains characteristics
against the data indicated on
the plate. The identification plate
bearing the technical data, serial
number and brand name is visibly
positioned inside the appliance.
Do not remove this plate for any
reason.
• Make sure that the plug and socket
are of the same type.
• Avoid using adapters, gang sockets
or extensions as these could cause
overheating and a risk of burns.
• The plug must always be accessible
when the appliance is installed.
• Leave the appliance standing ver-
tically for at least two hours before
turning it on for the first time.
• If it is necessary to replace the
power cable, this must be performed
by an authorised technician from
Technical Support Service.
28
Instructions
Installation
6.2 Positioning
• Position the appliance with the aid
of a second person.
• Never use the open door to lever
the appliance into place when
fitting.
• Avoid exerting too much pressure on
the door when open.
• The appliance must not be exposed
to direct sunlight.
• The appliance must not be placed
near sources of heat. If this is not
possible, a suitable insulation panel
must be used.
• Do not use the appliance outdoors.
Choice of location
Always install the appliance in a dry
place with satisfactory ventilation.
• The appliance must not be installed
near heat sources. If this is not possi-
ble, a suitable insulation panel must
be used.
• If installed underneath wall units, at
least 5 cm clearance must be left.
• Ensure that the appliance is located
with sufficient space for the door to
open and for the internal drawers
and shelves to be removed, if neces-
sary.
Heavy appliance
Crushing hazard
Pressure on the open door
Risk of damages to the ap-
pliance
Advertisement
Table of Contents
