Handset Battery Charging; Belt Clip Installation - ClearSounds A50E Installation Manual & User Manual

IMPORTANT! Only use AAA NiMH rechargeable batteries. DO NOT USE REGULAR
ALKALINE OR CARBON BATTERIES!

Handset Battery Charging

Handset batteries MUST be connected before beginning initial charging!
1. Place the handset into the charger. The charge indicator LED on the charger will
light RED.
2. IMPORTANT: The batteries in the handset must be fully charged for 24 hours before
using the telephone for the first time.
3. After the batteries are fully charged, check for dial tone by pressing the /* button
on the handset.
Fully charged batteries provide an average talk time of about 4 hours, or standby time of
about 8 days. Talk time & standby time may vary depending on operating conditions.
Low Battery Indicators
When the handset batteries get low during a call, there will be a warning tone and the
low battery icon will appear on the Caller ID display. Simply place A50E handset into the
charger to begin recharging. Make sure the contact points are touching and the charge
indicator LED is lit RED.
The battery level can also be monitored via the battery charge icon. This icon appears
while the phone is in standby mode and indicates the condition of the batteries.

Belt Clip Installation

You may choose to use the optional belt clip provided with your handset (See diagram #2
below).
1. To attach, slide the belt clip down onto the grooves. Press the tabs on the belt clip
into the slots to attach.
2. To remove, lift one side of the belt clip with your thumbnail and push back.
4
(Diagram #2) - Install and remove the belt clip