Echo PAS-225VP Operator's Manual page 45

PAS-225/SB/VP/VPB
If the engine is adjusted for operation above 330 m (1100 ft.) ASL, the
carburetor must be re-adjusted when operating the engine below
330 m (1,100 ft.) ASL, otherwise severe engine damage may result.
Note: Every unit is run at the factory and the carburetor is set in
compliance with emission regulations. Carburetor
adjustments, other than idle speed, must be performed by an
authorized dealer.
The cutting attachment may be moving during carburetor
◆
adjustments.
Wear your protective equipment and observe all safety
◆
instructions.
For units equipped with a clutch, be sure the cutting
◆
attachment stops moving when the engine idles.
When the unit is turned off, make sure the cutting
◆
attachment has stopped before the unit is set down.
1. Check idle speed and reset if
necessary. If a tachometer is
available, idle speed screw (A)
should be set to the
specifications found on
"Specifications" page of this
manual. Turn idle screw (A)
clockwise to increase idle
speed; counterclockwise to
decrease idle speed.
When carburetor adjustment is completed, the cutting
attachment should not move at idle, otherwise serious personal
injury may result.
X7732274006
© 09/21 ECHO Incorporated
MAINTENANCE
A
A
45