If
Camera freezes up
when a card is
inserted or
removed.
Memory card full.
Memory card and
internal memory
full.
The Reset Camera
feature did not
take effect.
Pictures taken on a
tripod are blurry.
Pictures that have
KODAK PERFECT
TOUCH
Technology
applied (twice) are
of lower image
quality.
Camera/computer communications
If
Cannot transfer pictures.
(The Add New Hardware Wizard
cannot locate drivers.)
www.kodak.com/go/support
Try one or more of the following
■
Turn the camera off, then back on. Make sure the camera is turned off
before inserting or removing a card.
■
Insert a new card
(page
37), or delete pictures
■
Transfer pictures to the computer
internal memory
Caution: Formatting a card deletes all pictures and videos,
including protected files.
■
After using the Reset Camera feature
off and then on again.
■
Occasionally, a tripod interferes with the camera's image stabilizer. In
the Setup menu, set Image Stabilizer to Off
■
If PERFECT TOUCH Technology has been applied to a picture on the
camera, do not apply it again when the picture is on the computer (or
on a KODAK Picture Kiosk).
NOTE: PERFECT TOUCH Technology is automatically applied to Pictures taken
in Smart Capture mode.
Try one or more of the following
■
■
(page
4), transfer pictures to the computer
(page
(page
(see page
35).
Disconnect USB cable. Close all open applications.
Re-install the software
Disconnect the USB cable. Close all open applications.
Re-install the software
18).
37), then format the card or
(see page
35), turn the camera
(see page
34).
(page
36).
(page
36).
Getting help
47