When The Oven Is Working - Smeg MP722PO Instruction Manual

Delayed Start Time (Automatic cooking)
1. When PT1 is pressed to define a delayed start
time the corresponding light
DSP1 shows the current time and DSP 2
shows "Auto".
2. Turn PT1 to the right or left to change the
delayed start time.
3. Press PT2 to validate the delayed start time.
4. The oven enters in an idle state waiting for the
defined start time. DSP3 shows the selected
function and DSP1 and DSP2 show all the
defined parameters
continuously alternating.
5. If you wish to start the function before the
selected time, just press PT2.
6. If you wish to cancel the programming, press
PT2 for 3 seconds.
20 / EN 20
starts to blink,
for the function
Use

3.8. When the oven is working...

Interrupting a cooking cycle
You can stop the cooking process at any time by
pressing the Start/Stop key once or by opening the
oven door. In both cases:
Microwave
immediately.
The grill is de-activated but is still very hot.
Danger of burning!
The timer stops and the display shows the
remaining amount of operating time.
If you wish, at this time you can:
Turn or stir the food to ensure it will be
evenly cooked.
Modify the process parameters.
Cancel the process by pressing PT2 for 3
seconds.
To restart the process, close the door and press
PT2.
Modifying parameters
The operating parameters (time, weight, power,
etc.) can only be modified when the cooking
process has been interrupted. Proceed as follows:
Press PT1 approximately 5-6 seconds to
activate the parameter modification mode.
The symbol starts to blink. Turn PT1 to
the right or left to change the remaining
cooking duration.
Press PT1 for 3 seconds to validate and the
next parameter light starts to blink. Proceed
as described in the active function chapter to
modify the remaining parameters.
Press PT2 to continue the cooking process.
Cancelling a cooking cycle
1. If you wish to cancel the cooking process,
press PT2 for 3 seconds.
2.
You will then hear a beep and the oven returns
to the OFF setting.
End of a cooking cycle
At the end of the process you will hear three beeps
and the display will show the word "End".
The beeps are repeated every 30 seconds until
the door is opened or PT2 is pressed. The oven
returns to the OFF setting
emission is stopped