Removing The Memory Module(S); Replacing The Memory Module(S) - Dell Inspiron 1545 Service Manual

Hide thumbs Also See for Inspiron 1545:
Table of Contents

Advertisement

Back to Contents Page
  Memory
Dell™ Inspiron™ 1545 Service Manual 
  Removing the Memory Module(s)
  Replacing the Memory Module(s)
 
CAUTION:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
as a connector on the back of the computer).
NOTICE:
computer.
NOTICE:
covered by your warranty.
You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Setup Guide for information on the
memory supported by your computer. Install only memory modules that are intended for your computer.
NOTE:
Memory modules purchased from Dell are covered under your computer warranty.
Your computer has two user-accessible SODIMM sockets that can be accessed from the bottom of the computer. The DIMM B memory module is located directly
above the DIMM A memory module located on the bottom of the computer.
NOTICE:
module in the connector labeled "DIMM B."
 Removing the Memory Module(s)
 
1. Follow the instructions in
 
2. Remove the base cover (see
NOTICE:
 
3. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
 
4. Remove the memory module from the connector.
1
memory module connector
3
memory module
 Replacing the Memory Module(s)
 
1. Align the notch in the edge of the memory module with the tab in the memory module connector.
 
2. Slide the module firmly into the slot at a 45-degree angle, and press the module down until it clicks into place. If you do not hear the click, remove the
module and reinstall it.
NOTE:
If the memory module is not installed properly, the computer may not boot.
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
To help prevent damage to the system board, remove the main battery (see
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not 
If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMM A" before you install a
Before You
Begin.
Removing the Base
To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.
2
securing clips (2)
 
 
UserManuals.info
Before Working Inside Your
Cover).
Computer) before working inside the

Advertisement

Table of Contents
loading

Table of Contents