Removing The Memory Module - Dell Inspiron 1420 Service Manual

Back to Contents Page
Memory
Dell™ Inspiron™ 1420/Dell Vostro™ 1400
Service Manual
Removing the Memory Module
Replacing the Memory Module
You can increase your computer memory by installing memory modules on the system board. Install only memory modules that are intended for your computer.
NOTE: Memory modules purchased from Dell are covered under your computer warranty.
Your computer has two user-accessible SODIMM sockets, DIMM A and DIMM B accessed from the bottom of the computer.
NOTICE:
a module in the connector labeled "DIMMB." Insert memory modules at a 30-degree angle to avoid damaging the connector.
NOTE: For optimal performance, identical memory modules should be used in each connector.
NOTE: If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.
CAUTION:
Removing the Memory Module
NOTICE:
(such as a connector on the back of the computer).
1. Follow the procedures in
2. Turn the computer over.
3. Loosen the captive screws from the memory module cover.
4. Lift the memory module cover and set it aside.
1 captive screws (3)
NOTICE:
5. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
6. Remove the module from the connector.
Great user manuals database on
If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMMA" before you install
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
Before You Begin.
2 memory module cover
To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.
UserManuals.info