Ryobi OWS1880 Manual page 7

1
Always wear safety goggles or safety
glasses with side shields, a dust mask,
non-slip, heavy-duty protective gloves,
and non-skid, protective footwear that will
protect your feet and improve your footing
on slippery surfaces when operating the
product.
4
1
2
Unscrew the tank cap by turning it counterclockwise. Remove the tank cap from the tank
and set aside. Carefully pour the desired amount of liquid into the tank (up to 7.5 litres).
NOTE: Spray solutions may be premixed and poured into the sprayer, using a funnel if
needed. If using a measuring container other than the measuring cup, or if using a funnel
to fill the tank, make sure to thoroughly clean and rinse these items after use. If premixing
the spray solution, rinse the container used for mixing.
Re-attach the tank cap back onto the sprayer. Turn the tank cap clockwise and tighten
securely.
6
Turn on the product by pressing the on/off
button.
2
1
3
2
Insert the spray wand into the handle.
Slide the o-ring towards the handle. Install
the threaded coupler onto the handle and
tighten securely. Rotate the nozzle until it is
aligned with the handle. Slide the nut onto
the threaded coupler and tighten securely.
Ensure that the spray wand is securely
attached to the handle.
3
7
Start the flow of liquid at the spray wand by
pressing the trigger. Releasing the trigger
stops the flow of liquid at the spray wand.
3
1
2
Insert the hose end into the opening on
the threaded coupler. Slide the nut over
the hose and threaded coupler, and hand
tighten. Insert the hose end into the hose
connector. Slide the nut over the opening
and hose end, and hand tighten. Do not
overtighten the nut. Make sure that the
hose connection is secured on both ends.
5
4
5
Install the battery pack in the product. Make
sure that the latches on each side of the
battery pack snap in place and that the
battery pack is securely attached before
using the product.
Press the on/off button to turn off the
product.
Getting started
4
4
3
6
7