Clearing The Cmos - AOpen AP61 User Manual

Selecting the Flash ROM Type
The onboard jumper JP9 allows you to select the Flash ROM type
that you wish to support. If a 5V Flash ROM is in use, you must set
JP9 to 1-2. Reset it to 2-3 to support a 12V Flash ROM.
5V
12V

Clearing the CMOS

You need to clear the CMOS if you forget your system password. To
do this, shut off the system power and short JP11 for a few seconds.
Then reset the jumper to normal setting by removing the jumper cap
and leaving it open. Enter Setup to specify a new password.
Normal
Clear CMOS
User's Guide
Hardware Setup
JP9
(default)
JP11
(default)
2-9