Philips 24PHS5507/12 Service Manual page 24

5.2.4 How to Clear the Error Buffer
The error code buffer is cleared in the following cases:
• By using the CLEAR command in the SAM menu
• By using the CLEAR command in the Factory mode:
• By using the following key sequence on the remote control transmitter: "062599" directly followed by the OK button.
• If the contents of the error buffer have not changed for 50 hours, the error buffer resets automatically.
Note: If you exit SAM by disconnecting the mains from the television set, the error buffer is not reset.
5.2 Panel Code
Press the following key sequence on a standard RC transmitter: "062598" directly followed by MENU and "xxx", where "xxx" is a 3 digit decimal value
of the panel type: see column "Display Code" in below tab. After resetting the Display Code, restart the set immediately.
CTN_ALT BOM#
24PHS5507/12
24PHS5507/12
24PHS5537/12
24PHS5537/12
32PHS5507/12
32PHS5507/12
32PHS5507/60
32PHS5507/60
32PHS5527/12
32PHS5527/12
43PFS5507/12
43PFS5507/12
43PFS5507/60
DV
FZ1 TPT236B5-AT024.H S11H
FZ2 TPT236WH-J1P01.N SCBD
FZ1 TPT236B5-AT024.H S11J
FZ2 TPT236WH-J1P01.N SCBK
FZ1 TPT320WH-H2F01.D S04K
FZ2 TPT320WH-AT022.H
UZ1 TPT320WH-H2F01.D S04K
UZ2 TPT320WH-AT022.H
FZ1 TPT320WH-H2F01.D S04L
FZ2 TPT320WH-AT022.H S2Q
FZ1 TPT430WF-FHBF90.K S9MPAM
FZ2 TPT430WF-FHBF20.K TDPD
UZ1 TPT430WF-FHBF90.K S9MPAV
Panel Type Display Code
42
46
43
47
44
48
44
48
44
48
45
49
45