Yamaha VXS3SB Owner's Manual page 11

2-2
Attach the safety wire to the speaker.
Attach the safety wire so that its clasp fits inside the groove on
the speaker.
3
Connecting the cables
3-1
Run the cables from the power amp through the terminal cover.
3-2
Use a screwdriver to loosen the screws on the barrier strip, insert
the cables, and then tighten the screws. For information about
connecting the cables, refer to "Connections" on page 6.
Make sure the cables are secure and cannot be pulled out.
3-3
Use the included screws (4×16 mm) to attach the terminal cover.
4
Secure the speaker to the mounting bracket
4-1
Remove the grille.
4-2
Attach the speaker so that the r mark on the mounting bracket
is facing the r mark on the speaker.
VXS3SB / VXS3SW / CMA3SB / CMA3SW Owner's Manual
Installing on a wall or ceiling
r mark
11