High-speed data capture and pattern generator (7 pages)
Summary of Contents for Genie WRR-4
Page 1
4 Channel Long Range Wiegand Radio Receiver - Up to 60m WRR-4 Quick Start Guide Please read these instructions carefully before operating the unit and keep for further reference.
Page 2
Intro Section This Quick Start Guide is intended for experienced installing technicians. It is a basic reference to ensure all connections are properly made. Installation and wiring of systems must be in accordance with the National Electrical Code, ANSI/NFPA 70. The contents of this manual are subject to change without notice.
4 Channel Long Range Wiegand Radio Receiver - Up to 60m The Genie WRR-4 is a 4 channel long range Wiegand radio receiver that allows interface with a wide range of electronic access control systems by complying with the Wiegand communication protocol.
Page 5
Quick Start Guide 4 Channel Long Range Wiegand Radio Receiver - Up to 60m 1.4 Cable Requirements 24 AWG minimum, multi-conductor stranded with an overall foil shield, for example Belden 9540 or similar. Per the SIA’s Wiegand specification, maximum cable length is 500 feet (152.4 m).
Page 6
SMA jack connector. If a separate, external antenna is used, then the switch should be set in the EXT (external) position. For installations requiring a separate, external antenna, please refer to the WRR-4 External Antenna Reference Document. 1.12 Beeper Switch As shipped, the Receiver’s Beeper Switch is set in the ON position.