Installation Instructions - GE GMR04HASCS Owner's Manual & Installation Instructions

Preparing to install
the refrigerator.
Read these instructions completely and carefully.
Refrigerator Location
I
Do not install the refrigerator where the temperature will go below
50°F (10°C) because it will not run often enough to maintain
proper temperatures.
I
Install it on a floor strong enough to support it fully loaded.
I
If the 2 cubic foot model is placed on a countertop or stand,
the front surface of the door should be 3" or more back from the
edge of the countertop or stand to avoid accidental tipping of the
appliance during normal use.
I
Do not install it closer than 5" (13 cm) next to a range.
The following applies only to the 2, 3 and 4 Cubic Foot Models:
I
Do not install it in a recessed area.
I
Do not build in the refrigerator.
Clearances
Allow the following clearances for ease of installation and proper
air circulation.
Sides
Top
Back
*1-1/4" (32 mm) for hinge side clearance
**From the rear cabinet surface to the wall
Turn counterclockwise to raise,
clockwise to lower.
2, 3 and 4
Cubic Foot Models
1/2" (13 mm)
2" (51 mm)
2" (51 mm)**
Leveling Legs
Adjustable legs at the front corners of the refrigerator
should be set so the refrigerator is firmly positioned on
the floor and the front is raised just enough that the
door closes easily when opened about halfway.
To adjust the leveling legs, turn the legs counterclockwise
to raise the refrigerator, clockwise to lower it.
6 Cubic Foot
Model only
0" (0 mm)∗
0" (0 mm)
0" (0 mm)
(on some models)
ge.com
9