Trouble Hooting - Toshiba AW-DUK1300K Series Owner's Manual

MAINTENANCE
Trouble Shooting
If the appliance does not start or it stops during the operation, initially try to find a solution
to the problem based on the table below.
Description
If the power is off .
If the wate
No washing
not work if the water amount does not reach the required water level)
If it is set to "Preset" washing mode. (It will only start to work until the
reservation time is reached)
If the power is off or the fuse is burned out.
If the water supply is cut off or the water pressure is too low.
If the inlet hose is properly connected and the water tap is opened.
No water flows in
If the filtering screen of inlet valve is blocked by dirt.
If the "Start / Hold" button is pressed after the power switch is pressed.
Abnormal draining If the end of the water drain hose is placed very high.
If the end of water drain hose is
If the
If
Abnormal spin clothes are loaded in the machine.
If the washer is not placed in stable condition or it is placed
state. (The ground is not flat).
Description
Alarm for abnormal
E1
water
Alarm for water
E2
water draining
Alarm for lid
E3
before wash and spin.
Unbalanced wash load
E4
during spinning
E7-1
E7-2
Abnormal behavior
with dangerous fault.
E7-3
(break wires brake sensors)
E7-4
E7-5
FXX
Others
Note!
• After the checking, try to use the appliance again ,If problems persist or the
display shows other alarm code again, contact the service center
• E1-E4 alarm clear on some models need to be stimulated by "Start" button
r volume reache the required water level.
top lid is closed.
most of the clothing are at one side of the drum or if too many
Reason
filling .
unfinished
that is not closed
, ,
Otherwise, contact the service center.
Inspection Items
immersed in and blocked by a pool of water .
Solution
Check the water tap is if
opened or not.
Check if the end of the drain hose is placed
too high,If it is immersed in and blocked
Close the lid.
Evenly distribute the clothes in
the drum by hand.
E7-1 E7-2 E7-3 E7-4 E7-5 appears after
pressing the power button,
for service.
If E7-1 E7-2 E7-3 E7-4 E7-5 appears
during the operation , press the power
button to stop the machine.
Call for service if no solutions work.
10
20
(The washer will
an inclined
Please call
.
.