YORKVILLE AudioPro AP1200 Owner's Manual page 10

AP1200 OWNER MANUAL / GUIDE D'OPERATION
SPECIFICATIONS
Page 9
CROSS TALK:
INPUT IMPEDANCE:
INPUT SENSITIVITY:
CMRR (bal input):
CONTROLS:
DISPLAYS:
FREQ. RESPONSE:
HUM AND NOISE:
DC OFFSET:
PROTECTION:
COOLING:
SLEW RATE:
DAMPING FACTOR:
MAX OUTPUT AMPS:
TURN ON/OFF:
EFFICIENCY:
WEIGHT:
SIZE:
TRANSFORMER:
POWER
CONSUMPTION:
-75 dB below full output at 1KHz,-60 dB below full output, 20 Hz - 20 KHz.
30Kohms balanced, 20 Kohms unbalanced.
1.4 VRMS sine wave = full power. (33 dB gain).
Typical 66 dB, minimum 54 dB. (20 Hz - 20 KHz).
Rotary GAIN controls, MONO/STEREO/BRIDGE, FILTER, LIMITER
switches.
2x CLIP, 2x ACTIVITY, PROTECT, POWER ON. (LEDS)
Within 1dB, 20 Hz to 20 KHz, (50 Hz boost SW out).
-103 dB below max output RMS voltage, unweighted.
Less than 30 millivolts.
Fully protected: DC, LOAD and THERMAL.
Anodized AL. Heatsink with DC servo controlled fan.
Power amp: 25 V/uS, 50 V/uS in bridged mode.Rise time limited to 18 V/
uS by input filter).
> 600, 20 Hz - 400 Hz, into 8 ohms. (plenty)
60 Amperes repetitive peak, 30 amperes continuous into resistive loads.
60 Amps peak and 30 Amps for 20mS repetitive at 0 voltage point when
driving phase shifted loads.
< 15 milliwatt / seconds, 0.5 Wpk. (1s on delay)
Better than 75% at full power into 4 Ohms.
33 pounds. 15 Kilograms.
3.5" x 19" x 15.75 (front panel to binding posts)
Toroidal.
Will not exceed 1440 Watts.