Table of Contents
Advertisement
•
On the front panel of the A‑16D note that the yellow chan‑
nel LED will light for any A‑Net output that has DC power
connected.
•
Connect a Cat‑5e cable from the powered A‑Net output on
the A‑16D to the A‑Net input on the Personal Mixer.
•
The Personal Mixer's
that a valid A‑Net signal is present.
•
Continue connecting up to eight Personal Mixers in this
manner.
In this example, DC power is being added to ports 1 and 6 on the A-16D.
DC power plus A-Net will be supplied via the Cat-5 cable to A-16II Personal
Mixers connected to these ports. Personal Mixers connected to the
remaining A-Net ports must use their power supplies locally.
DC power supplies shown in the diagram make look different than those
included with your Aviom product.
P N
: The DC power supply plugged into a Remote DC Power port on the
ote
rear panel of the A‑16D can power only one Personal Mixer. If you
start a daisy chain from a Personal Mixer powered remotely from an
A‑16D, all additional Personal Mixer units will need a source of DC
power.
Each Personal Mixer that is powered remotely no longer needs a power
supply connected to its rear panel. If this happens accidently, however, note
that you cannot harm the system.
A-16D A-N
D
u
et
istributor
ser
A‑Net Active LED will light to indicate
G
uiDe
13
Advertisement
Table of Contents
