Advertisement
ENGLISH
General precautions
Read the instructions carefully before
beginning the installation and carry
out the procedures as specifi ed by the
manufacturer. • Only use this product
for its intended purpose. Any other
use is hazardous. • The manufacturer
cannot be held liable for any damage
caused by improper, unreasonable or
erroneous use. • Before connecting
up the electrics, disconnect the power
supply and any batteries.
Dismantling and disposal
Dispose of the packaging and the device
responsibly at the end of its life cycle, in
compliance with the laws in force in the
country where the product is used. The
recyclable components are marked with the
material symbol and ID.
THE DATA AND INFORMATION IN THIS
MANUAL MAY BE CHANGED AT ANY TIME
AND WITHOUT NOTICE.
MEASUREMENTS ARE IN MILLIMETRES,
UNLESS STATED OTHERWISE.
Description
Limit-switch adjustment device for ATS
gearmotors.
Description of parts
1
Limit-switch adjustment device
2
Power LED
3
3-pole terminal block
4
LED warning light: limit-switch closing
5
LED warning light: limit-switch opening
6
9-pole terminal block connector
7
Power switch
8
FROR cable 3x1 mm2 (*)
9
Battery 9 V type 6F22 or 6LR61 (*)
(*) Accessory not supplied.
Inserting/replacing the battery
A
To insert or replace the battery (not
supplied), remove the upper casing using
a screwdriver.
Connecting the device and
adjusting the limit-switch points
Procedure for 24V gearmotors
Perform these operations on both
gearmotors.
Release the gearmotor.
B
Manually open the leaf to the desired
point.
Remove the protective covers to access
the gearmotor terminal block and the limit-
switch adjustment rods.
C
Disconnect the 9-pole terminal block
from the gearmotor board assembly and
connect it to the limit-switch adjustment
device connector.
Advertisement
