To Prevent The Outdoor Unit From Falling Over; Mounting The Indoor Unit; About Mounting The Indoor Unit; Precautions When Mounting The Indoor Unit - Daikin Altherma 3 R ECH2O Installer's Reference Manual

7.3.7 To prevent the outdoor unit from falling over

7.4 Mounting the indoor unit

7.4.1 About mounting the indoor unit

7.4.2 Precautions when mounting the indoor unit

7.4.3 To install the indoor unit

ERLA11~16DAV3+W1 + EBSH/X(B)11+16P30+50DF
Daikin Altherma 3 R ECH₂O
4P663482-1B – 2022.07
In case the unit is installed in places where strong wind can tilt the unit, take
following measure:
1 Prepare 2 cables as indicated in the following illustration (field supply).
2 Place the 2 cables over the outdoor unit.
3 Insert a rubber sheet between the cables and the outdoor unit to prevent the
cables from scratching the paint (field supply).
4 Attach the ends of the cables.
5 Tighten the cables.
When
You have to mount the outdoor and indoor unit before you can connect the
refrigerant and water piping.
Typical workflow
Mounting the indoor unit typically consists of the following stages:
1 Installing the indoor unit.
INFORMATION
Also read the precautions and requirements in the following chapters:
▪
"2 General safety
▪
"7.1 Preparing the installation
1 Lift the indoor unit from the pallet and place it on the floor. Also see
handle the indoor
4
precautions" [ 10]
site" [ 4 68]
4
unit" [ 26].
7 Unit installation
|
"4.2.3 To
Installer reference guide
91