GE Profile DPGT650GH Technical Service Manual page 33

Note: Proper leveling of the dryer is vital for
accurate sensor drying. Excessive rearward
adjustment will cause clothes to tumble toward the
rear of the drum, preventing contact with the sensor
rods, thus producing a false dryness reading.
To test the moisture sensor circuit:
1. Place the dryer in service test mode:
a. Press and hold the LESS TIME button and
the WRINKLE CARE button. The display
will show t1.
b. Press the CYCLES button to navigate to
Test T5.
2. Press the START button to begin the test.
The test display should show a reading from 30 to
255.
Sensor Rods
– 33 –