Important Precautions; Assembly Instructions - Kärcher K 2.97 M Operator's Manual

IMPORTANT PRECAUTIONS – continued
PRECAUTIONS
Water Supply (Cold Water Only)
• Water hose must be at least 3/4 inch in
diameter.
• Flow rate of water supply must not fall
below 2.5 GPM (gallons per minute).
• Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
• The water supply temperature must not
exceed 104°F/40°C.

ASSEMBLY INSTRUCTIONS

Step 1
4
Insert wheels into side holes
at the bottom of the pressure
washer and snap into place.
Step 4
Slide the trigger gun holder
into track of the pressure
washer.
• Never use the pressure washer to draw in
water contaminated with solvents, e.g.
paint thinner, gasoline, oil, etc.
• Always prevent debris from being drawn
into the unit by using a clean water
source.
•
Step 2
Place the wheel carriage
onto the mounting brackets
on the sides of the washer
and align the four holes.
Snap into place.
Step 5
Attach piece at the bottom of
the pressure washer.
Step 6
Pull out the locking slide from the right side
of the trigger gun handle, and insert the
small end of the high pressure hose into
place. Push the locking slide back into the
trigger gun to lock the hose in position.
Save these instructions!
Step 3
Slide the handle into the top
slot of the wheel carriage
and snap into place.