General Instructions - HELIX ULTIMATE P SIX DSP User Manual

Congratulations!
Dear Customer,
Congratulations on
innovative and high-qual ity HELIX product.
Thanks to more than 30 years of experience in
research and development of audio products the
HELIX P SIX DSP ULTIMATE sets new standards
in the range of digital amplifiers.

General instructions

General installation instructions for HELIX
components
To prevent damage to the unit and possible injury,
read this manual carefully and follow all installa-
tion instructions. This product has been checked
for proper function prior to shipping and is guaran-
teed against manufacturing defects.
Before starting your installation, disconnect
the battery's negative terminal to prevent
damage to the unit, fire and / or risk of injury.
For a proper performance and to ensure full war-
ranty coverage, we strongly recommend to get this
product installed by an authorized HELIX dealer.
Install your HELIX P SIX DSP ULTIMATE in a dry
location with sufficient air circulation for proper
cooling of the equipment. The amplifier should be
secured to a solid mounting surface using proper
mounting hardware. Before mounting, carefully
examine the area around and behind the pro-
posed installation location to insure that there
are no electrical cables or components, hydraulic
brake lines or any part of the fuel tank located be-
hind the mounting surface. Failure to do so may
result in unpredictable damage to these compo-
nents and possible costly repairs to the vehicle.
your purchase of
We wish you many hours of enjoyment with your
this
new HELIX P SIX DSP ULTIMATE.
Yours,
AUDIOTEC FISCHER
General instruction for connecting the HELIX
P SIX DSP ULTIMATE amplifier
The HELIX P SIX DSP ULTIMATE amplifier may
only be installed in vehicles which have a 12
Volts negative terminal connected to the chassis
ground. Any other system could cause damage to
the amplifier and the electrical system of the ve-
hicle.
The positive cable from the battery for the com-
plete system should be provided with a main fuse
at a distance of max. 30 cm from the battery. The
value of the fuse is calculated from the maximum
total current input of the car audio system.
Use only suitable cables with sufficient cable
cross-section for the connection of HELIX
P SIX DSP ULTIMATE. The fuses may only be
replaced by identically rated fuses (3 x 20 A) to
avoid damage of the amplifier.
Prior to installation, plan the wire routing to
avoid any possible damage to the wire harness.
All cabling should be protected against possible
crushing or pinching hazards. Also avoid routing
cables close to potential noise sources such as
electric motors, high power accessories and other
vehicle harnesses.
en
17