Table of Contents
Advertisement
Available languages
Available languages
10
MiniEva • MiniEvaPower • MiniEvaLight
ELECTRICAL SPECIFICATIONS
The board can be powered through two terminals, "Primary power" and
secondary emergency power (optional) via the "RS485" bus terminal.
Primary power: from 200Vac to 250Vac with 50/60 Hz frequency
Ÿ
Optional secondary power: from 12Vdc to 18Vdc
Ÿ
Absorbed power:
Ÿ
Absorbed power with 4 powered relays: 4W
Absorbed power with 4 idle relays: 2W
Absorbed power with 4 2W idle relays with SPDT type contacts:
Ÿ
Cos = 1:
12A at 250Vac
12A at 30Vcc
Cos =0,4 L/R = 7 ms:
8A at 250 VAC
8A at 30 VDC
Maximum total load supported by the board: 3000VA (cos = 1)
Maximum switch voltage: 380 Vac, 125 Vdc
Ÿ
Maximum switch current: 16A
Ÿ
Maximum switch power: 4KW
Ÿ
Warning: If terminals are removed, cut-off power upstream (using the
circuit breaker). Removal when live could cause sparks, rusting pins
which could jeopardise good operations over time.
Working temperature: from -20°C to +85°C
Ÿ
Room humidity: from 0% to 85%
Ÿ
BOARD ASSEMBLY
The board is set to be installed on a 7-module control unit with DIN EN
50022 bar, using the track and lock tabs.
Thanks to the optional side rings, it can be installed on shunt boxes or light
walls with screws.
Do not obstruct the ventilation slats and do not expose the device to
dripping or spraying water.
Advertisement
Table of Contents
