Sony SRG-X40UH Operating Instructions Manual page 29

Color video camera
Hide thumbs Also See for SRG-X40UH:
Table of Contents

Advertisement

When the signal format is 50 or 25
You can choose from [1/1], [2/3], [1/2], [1/3], [1/4],
[1/6], [1/8], [1/12], [1/15], [1/20], [1/25], [1/30],
[1/50], [1/60], [1/100], [1/120], [1/150], [1/215],
[1/300], [1/425], [1/600], [1/1000], [1/1250],
[1/1750], [1/2500], [1/3500], [1/6000], [1/10000].
IRIS
When [MODE] is either [MANUAL] or [IRIS Pri],
you can change the iris setting.
You can choose from [F2.0], [F2.2], [F2.4], [F2.6],
[F2.8], [F3.1], [F3.4], [F3.7], [F4.0], [F4.4], [F4.8],
[F5.2], [F5.6], [F6.2], [F6.8], [F7.3], [F8.0], [F8.7],
[F9.6], [F10], [F11], [CLOSE].
AE SPEED
Select the adjustment speed for exposure
adjustment.
You can adjust the speed at which the camera
reaches the optimum exposure setting from [1]
(standard) to [48] (slow). Adjust this when the
brightness of the object changes
instantaneously.
This setting is available when [MODE] is [FULL
AUTO], [SHUTTER Pri], or [IRIS Pri].
EX-COMP
Turn this [ON] when you want to correct
brightness of a picture whose exposure is
already automatically adjusted. This setting is
available when [MODE] is [FULL AUTO], [SHUTTER
Pri], or [IRIS Pri]. The [LEVEL] setting is displayed
when this is turned [ON].
LEVEL
Set a level to adjust the brightness of a picture
whose exposure is already automatically
adjusted. Choose a value from [–7] to [+7] for the
level.
This is not displayed when [EX-COMP] is turned
[OFF].
GAIN LIMIT
Set the maximum gain when exposure is
automatically adjusted using gain. Choose a
value from [9dB] to [36dB] (in 3 dB increments).
When high-sensitivity mode is set to ON, the
available range is expanded from [21dB] to
[48dB] (in 3 dB increments).
This setting is available when [MODE] is [FULL
AUTO], [SHUTTER Pri], or [IRIS Pri]. You cannot
choose a value smaller than the [POSITION]
setting.
GAIN POINT
When you set [MIN SPEED] to be slower than the
output image frame rate, the shutter speed
controls exposure based on the [GAIN POINT]
setting. Normally, when exposure is controlled
with gain, noise becomes prominent if gain is
increased to make the image brighter. You can
decrease noise by adjusting the exposure with
lower shutter speeds after canceling gain
adjustments. When you do this, set [GAIN POINT]
to [ON] and set the [POSITION] to the gain at
which you want the shutter speed to change.
When the shutter speed reaches [MIN SPEED] for
exposure adjustment, the gain will increase to
adjust exposure. This setting is available when
[MODE] is either [FULL AUTO] or [IRIS Pri].
POSITION
This is enabled when [GAIN POINT] is turned
[ON]. When gain during exposure adjustment
reaches the value for [POSITION], exposure is
adjusted through a slower shutter speed. This
setting is available when [MODE] is either [FULL
AUTO] or [IRIS Pri]. You cannot choose a value
smaller than the [GAIN] setting.
MAX SPEED
Set the maximum (fastest) shutter speed when
exposure is automatically adjusted with the
electronic shutter.
This setting is available when [MODE] is either
[FULL AUTO] or [IRIS Pri]. You cannot choose a
value slower than [MIN SPEED].
When the signal format is 59.94 or 29.97
You can choose from [1/30], [1/50], [1/60], [1/90],
[1/100], [1/125], [1/180], [1/250], [1/350], [1/500],
[1/725], [1/1000], [1/1500], [1/2000], [1/3000],
[1/4000], [1/6000], [1/10000].
When the signal format is 50 or 25
You can choose from [1/25], [1/30], [1/50], [1/60],
[1/100], [1/120], [1/150], [1/215], [1/300], [1/425],
[1/600], [1/1000], [1/1250], [1/1750], [1/2500],
[1/3500], [1/6000], [1/10000].
MIN SPEED
Set the minimum (slowest) shutter speed when
exposure is adjusted with the electronic shutter.
This setting is available when [MODE] is either
[FULL AUTO] or [IRIS Pri]. You cannot choose a
value faster than [MAX SPEED].
When the signal format is 59.94 or 29.97
You can choose from [1/1], [2/3], [1/2], [1/3], [1/4],
[1/6], [1/8], [1/10], [1/15], [1/20], [1/30], [1/50],
[1/60], [1/90], [1/100], [1/125], [1/180], [1/250],
[1/350], [1/500], [1/725], [1/1000], [1/1500],
[1/2000], [1/3000], [1/4000], [1/6000], [1/10000].
When the signal format is 50 or 25
You can choose from [1/1], [2/3], [1/2], [1/3], [1/4],
[1/6], [1/8], [1/12], [1/15], [1/20], [1/25], [1/30],
[1/50], [1/60], [1/100], [1/120], [1/150], [1/215],
[1/300], [1/425], [1/600], [1/1000], [1/1250],
[1/1750], [1/2500], [1/3500], [1/6000], [1/10000].
29

Advertisement

Table of Contents
loading

This manual is also suitable for:

Srg-h40uh

Table of Contents