Electrolux IK2550BNR User Manual page 72

72 www.electrolux.com
Problem
The compressor does not
start immediately after
pressing the ActionFreeze,
or after changing the tem-
perature.
The compressor does not
start immediately after
pressing the Shopping, or
after changing the tempera-
ture.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set. The ActionFreeze or
dEMo appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The ActionFreeze is
switched on.
The Shopping is switched
on.
This is normal, no error
has occurred.
This is normal, no error
has occurred.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
Shopping function is
switched on.
The appliance is in dem-
onstration mode.
The temperature regulator
is not set correctly.
Solution
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "ActionFreeze func-
tion".
Refer to "Shopping function".
The compressor starts after a
period of time.
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off ActionFreeze or
Shopping manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "ActionFreeze
or Shopping function".
Keep the OK pressed for ap-
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.