Connecting Speakers - JVC UX-J55MDAH Instruction Manual

AM antenna
1 2
3
AM loop antenna
(supplied)
1
If the cords are covered with insulation,
remove a short section of insulation at the
end of each cord by twisting and pulling it
off.
2
Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
3
Turn the AM loop antenna until you have
the best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
loop antenna must remain connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
7

Connecting Speakers

Vinyl-covered wire
(not supplied)
Speaker cord
1
2
3
4
FOR UX-J66V:
1
2
Gray
RIGHT
LEFT
Speaker
MAIN SPEAKERS
cord
CAUTION: SPEAKER IMPEDANCE 6 -16
Blue
INPUT INPUT
Right speaker
FOR UX-J55V:
SPEAKERS
RIGHT
SPEAKER
IMPEDANCE
6 - 16
Right speaker
If the cords are covered with insulation,
remove a short section of insulation at the
end of each cord by twisting and pulling it
off.
Press and hold the clamp of the speaker
terminal as illustrated.
Insert the end of the speaker cord into the
terminal.
Match the polarity between the unit and the speaker
terminals: ª to ª and · to ·.
Release your finger from the clamp.
3
Red
RIGHT
LEFT
Speaker
SUBWOOFERS
cord
Black
INPUT INPUT
Left speaker
LEFT
Speaker cord
Left speaker