Programming The Playing Order Of The Tracks -Program Play - JVC HX-Z10C Instructions Manual

Programming the Playing Order of the Tracks
—Program Play
You can arrange the playing order of the tracks before you
start playing. You can program up to 100 tracks.
• To use Repeat Play (see page 22) for Program Play, press
REPEAT after starting Program Play. Only REPEAT 1 and
REPEAT ALL can be selected for Program Play.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step 2 again.
1
Load discs.
• If the current playing source is not the CD player, press
CD 3¥8, then 7 before going to the next step.
2
Activate Program Play.
On the unit:
Press CD PLAY MODE repeatedly
until "CD PROGRAM" appears
on the display.
• Each time you press the button, the play
mode changes as follows:
CD PROGRAM
Total track number and
total playing time (Continuous Play)
On the remote control:
Press PROGRAM so that
"CD PROGRAM" appears
on the display.
The PROGRAM indicator lights up on the display.
• If a program has been stored in memory, the program is
called up.
3
Press one of the disc number buttons (CD1 –
CD5) to select the disc you want.
CD1 CD2
Track number
Disc number
CD PLAY MODE
CD RANDOM
PROGRAM
5
PROGRAM CANCEL
REC
TAPE
DOM
START/STOP
CD3 CD4 CD5
Program step number
4
Select a track from the selected disc in step 3 .
• Program step numbers exceeding 100 cannot be
programed.
• When making programs from MP3 discs, the unit only
recognizes tracks like audio CD. You cannot make
programs using group numbers.
On the unit:
Turn ¢ / 4
to select the
track number,
then press
SET/DISPLAY.
On the remote control:
Press the number buttons.
• For how to use the number buttons,
see "To go to another track directly
using the number buttons" on page
19.
5
Program other tracks you want.
• To program tracks from the same disc, repeat step 4 .
• To program tracks from a different disc, repeat steps 3
and 4 .
6
Press CD 3¥8.
The tracks are played in the order you
have programed.
• If the playing disc is an MP3 disc, the MP3 indicator
lights up.
To stop playing, press 7.
To exit from Program Play, press CD PLAY MODE
repeatedly until the PROGRAM indicator goes off (or press
PROGRAM on the remote control) after playback stops.
• If you try to program a 101st track, "CD FULL" appears on the
display.
• If you have tried to program a track from an empty tray, "NO
READ # (number)" or "NO DISC # (number)" will appear on the
display for 2 seconds.
• If you have tried to program a track number that does not
exist, it is ignored.
• If you try to open a disc tray during Program Play, the disc
tray does not come out. Open disc trays after canceling Program
Play.
• When "NO READ" appears on the display
You are selecting the disc that the unit has not read yet.
Continued
SET
/DISPLAY
FM MODE
CD
20