Advertisement
Caution When Assembling
As bridge keys protrude from the neck, upper joint,
lower joint, and bell on the alto and bass clarinets, be
careful not to damage or bend these parts when assem-
bling the instrument. Th e bell section and tone hole
on the alto clarinet is thin so please use extra caution
when assembling these parts.
1.
Attaching the bell to the lower joint.
Holding the bottom of the bell in your right
hand, slide the bell section partially onto the
joint.
2.
Hold down the pad plate on the bell with your
right thumb then slide the bell all the way
onto the joint.
When assembling, insert the peg at this point
to provide stability when standing the instru-
ment on the fl oor.
3.
Assemble the upper and lower joints.
While checking the position of the bridge keys,
align the upper and lower bridge keys and slide
the upper and lower joints together without
twisting.
* Make sure the upper and lower bridge keys do not
come into contact with each other.
Alto Clarinet / Bass Clarinet
Bell
4.
Attach the neck to the upper joint.
On the alto clarinet
After attaching the mouthpiece to the
neck, insert the neck into the upper joint.
On the bass clarinet
Attach the lower and upper neck sections
and secure them with the fastening screw.
Next, attach the mouthpiece onto the
upper neck and then the mouthpiece/neck
assembly into the upper joint.
5.
Adjust the length of
the peg according to
your posture.
Assembly
bridge key
Peg
7
Advertisement
