Table of Contents
Advertisement
service@apatioboss.com
INSTALLATION INSTRUCTIONS
1. Ensure the desired mounting location can fit the unit in a horizontal orientation and is
near an outlet but free from from electrical cables. Communication lines, and pipes. And
the mounting location at least 1.8 m from the floor and at least 0.5 m from the ceiling.
2. In the canal of back side of the heater there are 4 square fastener washers 25×25mm.
Relieve 4 X M5*10 screws and fasten 2 brackets to the canal of the backside of the
heater by the help of screws.
3. Fasten the brackets at the appropriate distance of each other(45-55cm) .
45-55CM
- 10 -
service@apatioboss.com
4. Two other brackets are fastened by the wall Anchors at the appropriate distance on the
wall parallel to the floor(At least 1.8 m from the floor and at least 0.5 m from the ceiling).
5.Join the brackets on the heater with the brackets, fastened on the wall, with help of
figure screw-nuts. Install the heater under necessary angle(in the direction to the
area being heated).
M6*14 Bolt
Round Gasket
Hex Nut
ATTENTION:
Electric wiring for the heater has to be done by the qualified specialist.
- 11 -
Advertisement
Table of Contents
