Installing Your New Recorder; Basic Connections - JVC HR-J371EM Instructions Manual

Jvc hr-j371em: user guide
Table of Contents

Advertisement

INSTALLING YOUR NEW RECORDER

Basic
Connections
Aerial terminal
Back of TV
AV-IN terminals
AV Cable
(not provided)
Mains Power
Cord
Mains outlet
RF Cable
(provided)
AUDIO OUT/
VIDEO OUT
Connect the power plug to an AC
outlet before installing the lithium
battery.
pg. 5
It's essential that your video recorder be properly connected.
Follow these steps carefully. THESE STEPS MUST BE COM-
PLETED BEFORE ANY VIDEO OPERATION CAN BE PER-
FORMED.
CHECK CONTENTS
1
Make sure the package contains all of the accessories
listed in "Specifications" (
SITUATE RECORDER
2
Place the recorder on a stable, horizontal surface.
CONNECT RECORDER TO
TV
3
The connection method you use depends on the type
of TV you have.
TV Aerial
Cable
RF CONNECTION
To Connect To A TV With NO AV Input Terminals . . .
a– Disconnect the TV aerial cable from the TV.
b– Connect the TV aerial cable to the ANT. IN jack
c– Connect the provided RF cable between the RF
AV CONNECTION
To Connect To A TV With AV Input Terminals . . .
a– Connect the aerial, recorder and TV as per "RF
b– Connect an optional AV cable between the
CONNECT RECORDER TO
MAINS
Rear View
4
Plug the end of the mains power cord into a mains
outlet.
NOTE:
Use the conversion plug (not provided in certain areas)
depending on the type of your AC wall outlet.
ATTENTION
If you have finished all the necessary connections, go to
"Video Channel Set" on page 4, then perform Auto Set Up on
page 6; do NOT press the
control to turn on the recorder's power before you start Auto
Set Up.
pg. 43).
on the rear panel of the recorder.
OUT jack on the rear panel of the recorder and
the TV's aerial terminal.
CONNECTION".
AUDIO OUT and VIDEO OUT connectors on the
rear panel of the recorder and the TV's AV-IN
terminals .
button on the recorder/remote
3
EN

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hr-j377em

Table of Contents