Camera Ip Setup Command - Sony ILME-FR7 Manual

Camera IP Setup
Command
The following command is provided for setting
the IP address and camera name of a camera.
No. Name
1 Setting Protocol:
Inquiry
2 Setting Protocol:
Inquiry response
3 Setting Protocol:
Network settings
4 Setting Protocol:
Network settings
response
To set the network settings of a camera, use the
following sequence.
Connect the computer used for configuring to
the same network segment as the cameras.
1
Inquiry
The controller sends inquiry packets to UDP
broadcast address (255.255.255.255) on the
specified port number (52380). The camera
responds using inquiry response packets.
2
Network settings
The controller sends network setting packets
to UDP broadcast address (255.255.255.255)
on the specified port number (52380). The
camera refers to the MAC address units in
the packets and if the packets are a request
to itself, the camera returns an
acknowledgment (ACK) in the network
settings response.
If the camera configuration is unsuccessful,
it returns NACK in the network settings
response.
Description
Controller inquires about the
network settings of the
camera.
Camera responds to the
inquiry from the controller.
Controller configures the
network settings of the
camera.
Camera responds to the
network settings from the
controller.
Command
Inquiry
UDP
Broadcast address
(255.255.255.255)
Specified port
number (52380)
Inquiry response
UDP
Broadcast address
(255.255.255.255)
Specified port
number (52380)
Network settings
UDP
Broadcast address
(255.255.255.255)
Specified port
number (52380)
Network settings
response
UDP
Broadcast address
(255.255.255.255)
Specified port
number (52380)
*1: ASCII code.
*2: ASCII code. For NACK, returns "NAK:**-**-**-**-**-**".
*3: ASCII code. If necessary, a detailed message reply can occur
here. May be omitted.
Notes
• Up to 8 characters comprising alphanumeric
characters or spaces can be used for the
camera name (NAME).
• When the WRITE data in the inquiry response is
set to off, you cannot change the camera IP
address and camera name in the network
settings.
• After power to the unit is first turned on, WRITE
is set to off automatically after 20 minutes, at
which point the network settings are no longer
accepted.
23
Data
02
ENQ:network
FF
03
02
MAC:**-**-**-**-**-**
FF
MODEL:IPCARD
FF
SOFTVERSION:**.**.**
FF
IPADR:***.***.***.***
FF
MASK:***.***.***.***
FF
GATEWAY:***.***.***.***
FF
NAME:xxxxxxxx
FF
WRITE:on
FF
03
02
MAC:**-**-**-**-**-**
FF
IPADR:***.***.***.***
FF
MASK:***.***.***.***
FF
GATEWAY:***.***.***.***
FF
NAME:xxxxxxxx
FF
03
02
ACK:**-**-**-**-**-**
"xxxx"
FF
03
*1
*1
*1
*1
*1
*1
*1
*1
*1
*1
*1
*1
*1
*1
*2
*3