Advertisement
Reboot
If this TV should "freeze" (you can't operate anything), please push the "CH-" key and "VOL-" key on
the front panel at same time for at least 5 seconds (until the TV's power turns off). After the TV's power
turns off, you may turn it back on. If you still can't operate the TV after performing these steps, then
please disconnect it from the AC outlet and try again.
Update of CableCARD
If you use a CableCARD, sometimes your Cable Operator might want to update the software of
CableCARD. In this case, please follow any displayed messages. If you can't understand it, please
contact your Cable Operator.
4.
About i.LINK.
The TV supports the copy protection technologies of DTLA (Digital Transmission Licensing
Administer). It is impossible to record copy-limited broadcasting signals. When connecting to other
devices, only the operation of devices which support DTLA is guaranteed. In this TV, also the picture
of NTSC (480i) will not be outputted from the rear panel i.LINK port in order to protect the copyrights.
(If you need this function, use i.LINK to connect to a JVC D-VHS deck, then use the component output
of a D-VHS deck and set it to 480i in the D-VHS deck menu).
Connectable devices
Currently, the i.LINK function of this TV can only be used for D-VHS decks. In the future, other devices
may become available to utilize i.LINK. This TV can connect with JVC High Definition Camcorder
GR-HD1 in MPEG mode through i.LINK, and you can use the fundamental functions, but you can not
use the GR-HD1 in DV mode. (This TV is not able to recognize DV signals.)
Device recognition
i.LINK recognizes a connected device automatically. Also, this TV is recognized as a tuner by other
i.LINK devices because it takes a role of tuner. This TV can not recognize other tuners; therefore,
other tuners will not be listed in this TV's "Device List". Hence, it's impossible to watch a program on
this TV which is received by another tuner connected via i.LINK.
7
Advertisement
