Carrier ZONECC2KIT-B Installation And Start-Up Instructions Manual page 4

3. Properly seal joint using duct tape, mastic, or other approved
method. Do not allow mastic to come in contact with actuator.
4. Insulate damper using 1-1/2 in. to 2-in. insulation. (Check
your local codes.)
NOTE: All zone dampers and duct work must be properly
supported according to local codes or SMACNA standards.
RECTANGULAR METAL DUCT WORK
1. Make connections using S-lock and drives. (See Fig. 3.)
2. Properly seal joint using duct tape, mastic, or other approved
method. Do not allow mastic to come in contact with actuator.
MOUNTING
HUB
ACTUATOR
HOUSING
QUICK BLADE
RELEASE
BUTTON
(RED)
FIELD
INSTALLED
POWER WIRING
Fig. 1—Damper 24-vac Connections
Fig. 2—Insulated Round Metal Duct Work
3. Insulate damper using 1-1/2 in. to 2-in. insulation. (Check
your local codes.) (See Fig. 4.)
ROUND FLEXIBLE DUCT WORK
1. Slip 1 end of flexible duct work over 1 end of zone damper.
(See Fig. 5.)
2. Secure flexible duct to zone damper using SMACNA or other
approved method.
3. Properly seal joint using duct tape, mastic, or other approved
method. Do not allow mastic to come in contact with actuator.
4. Insulate damper using 1-1/2 in. to 2-in. insulation. (Check
your local codes.) (See Fig. 6.)
NOTE: All zone dampers and duct work must be properly
supported according to local codes or SMACNA standards.
POSITION
INDICATOR
ANGULAR
ROTATION
STOPS
MOUNTING
BRACKET
A95096
/ " STEEL STRAP
1
2
A95130
4
SUPPLY
AIR DUCT
Fig. 3—Rectangular Metal Duct Work
1 2
1 / " TO 2"
INSULATION
Fig. 4—Insulated Rectangular Metal Duct Work
FLEXIBLE
DUCT
Fig 5—Round Flexible Duct Work
Fig. 6—Insulated Round Flexible Duct Work
RECTANGULAR FIBROUS GLASS DUCT WORK
1. Insert 1 end of zone damper into 1 end of fibrous glass duct
work approximately 2 to 3 in. (See Fig. 7.)
2. Screw field-supplied screws and tabs into zone damper.
3. Properly seal joint using duct tape, mastic, or other approved
method. Do not allow mastic to come in contact with actuator.
S-LOCK
DRIVE
ZONE
DAMPER
A92478
A95131
ZONE
DAMPER
A95132
/ " STEEL STRAP
1 2
A95133