Operation - Husqvarna 395 XP G Operator's Manual

2. Remove the bar nuts, clutch cover and
transportation guard (A).
Note: If the clutch cover is not easy to remove,
tighten the bar nut, engage the chain brake and
release. A click is heard if it is released correctly.
3. Assemble the guide bar onto the bar bolts. Move the
guide bar to its most rear position.
4. Install the saw chain correctly around the drive
sprocket and put it in the groove on the guide bar.
WARNING: Always use protective
gloves when you assemble the saw
chain.
5. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
10
A
6. Align the hole in the guide bar with the chain adjuster
pin and install the clutch cover.
7. Tighten the bar nuts finger tight.
8. Tighten the saw chain. Refer to
of the saw chain on page 30 for instructions.
9. Tighten the bar nuts.
Note: Some models have only 1 bar nut.

Operation

To do a function check before you use
the product
1. Make sure that the chain brake operates correctly
and that it is not damaged.
To adjust the tension
594 - 002 - 08.06.2020