Maintenance - Husqvarna 372 XPG X-TORQ Operator's Manual

5. Make one or more cuts of sufficient depth necessary
to decrease the tension. Cut at or near the point of
maximum tension. Make the tree or branch break at
the point of maximum tension.
WARNING: Do not cut straight through a
tree or branch that is in tension.
WARNING: Be very careful when you
cut a tree that is in tension. There is a
risk that the tree moves quickly before or
after you cut it. Serious injury can occur
if you are in an incorrect position or if
you cut incorrectly.
6. If you must cut across tree/branch, make 2 to 3 cuts,
1 in. apart and with a depth of 2 in.
7. Continue to cut more into the tree until the tree/
branch bends and the tension is released.
8. Cut the tree/branch from the opposite side of the
bend, after the tension is released.
To use the product in cold weather
CAUTION: Snow and cold weather can
cause operation problems. Risk of too low
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
585 - 006 - 03.07.2020
1. In conditions with snow, a winter cover is available.
Assemble the winter cover on the starter housing.
The winter cover decreases the flow of cool air and
keeps snow away from the carburetor space.
Heated handles (372 XPG X-TORQ)
The product has heated front and rear handles. The
electrical heating coils are powered by a generator.
Push the switch to engage the heat in the handles. The
heat is on when you can see the red mark on the switch.
Electrical carburetor heating (372 XPG X-
TORQ)
Adjustment of the carburetor heating is done electrically
through a thermostat. This keeps the correct carburetor
temperature and prevents ice in the carburetor.

Maintenance

engine temperature or ice on the air filter
and the carburetor.
CAUTION: Remove the winter cover if the
temperature increases above 0°C/32°F. Risk
of too high engine temperature and damage
to the engine.
21