Opening The Door When The Programme Operates - Zanussi ZWS624A4S User Manual

OPENING THE DOOR WHEN THE DELAY
START OPERATES OR WHEN PROGRAMME
STARTS TO OPERATE
While a delay start operates or when the
programme has just started to operate, the
appliance door is locked and the indicator
on.
1. Press to pause the appliance.
The indicator starts flashing.
2. Wait about 2 minutes until the door lock
indicator stops flashing and goes off.
3. You can open the door.
4. Close the door and press the
The delay start or the programme continues to
operate.
When the programme has already
started and you pause the appliance,
but the indicator
and the door cannot be opened,
switch the appliance off to open the
door. Please refer to "Opening the
door when the programme operates".
OPENING THE DOOR WHEN THE
PROGRAMME OPERATES
While a programme operates, the appliance door is
locked and the indicator
CAUTION! If the temperature and
level of the water in the drum are too
high, you cannot open the door.
1. Turn the programme knob to position
deactivate the appliance.
2. Wait for some minutes and then open the
appliance door.
3. Close the appliance door.
4. Set the programme again.
AT THE END OF THE PROGRAMME
• The appliance stops automatically.
• The acoustic signal operates (if it is activated).
• In the display comes on.
• The indicator of the
• The door lock indicator
minutes, then goes off.
is
again.
does not flash
is on.
to
goes off.
flashes for a few
• You can open the door.
• Remove the laundry from the appliance. Make
sure that the drum is empty.
• Close the water tap.
• Turn the programme knob to position On/Off to
deactivate the appliance.
• Keep the door ajar, to prevent the mildew and
odours.
The washing programme is completed, but
there is water in the drum:
• The drum turns regularly to prevent the creases
in the laundry.
• The door lock indicator
flashes. The door stays locked.
• You must drain the water to open the door.
To drain the water:
1. Press . The appliance drains the water and
spins.
2. When the programme is completed, the door
lock indicator
When it goes off, you can open the door.
3. Turn the programme knob to position On/Off to
deactivate the appliance.
The appliance drains and spins
automatically after approximately 18
hours (except for Wool programme).
STAND-BY
About 5 minutes after the end of the washing
programme, if you do not deactivate the appliance,
the energy saving status activates.
The energy saving status activates also during set
up if no action occurs for about 5 minutes.
The energy saving status decreases the energy
consumption when the appliance is on the stand
by.
• All indicators go off.
• The indicator of the
• Press one of the options to deactivate the
energy saving status.
If you set a programme or an option
that ends with water in the drum, the
energy saving status function doesn't
activate to remind you to drain the
water.
is on. The indicator
flashes for a few minutes.
flashes slowly .
39