Instruction Manual
HASXMDE-IM-EX
01/2015
3.7
Powering up
3.7.1
Boot sequence
When the unit is powered up, a series of in-
ternal tests is automatically performed. During
this time the front panel keys are disabled,
3.7.2
Measurement display
The measurement display is shown
automaticaly on completion of the boot
•
sequence
when the MEASURE key is pressed
•
automatically after a set period of time
•
of inactivity (i.e. with no keys being
pressed).
The information displayed in the four lines of
the measurement display can be determined
by the operator:
Sample gas components, measuring
•
results and measuring units for each
channel
additional measurements, e.g. pressu-
•
re, gas fl ow, temperature
nothing (empty line)
•
The factory settings are as follows:
Line 1: measured value of channel 1
Line 2: measured value of channel 2
Line 3: measured value of channel 3
Line 4: measured value of channel 4
Note!
If less than four channels are installed in the
unit, only the values of the available channels
will be shown.
Emerson Process Management GmbH & Co. OHG
3.7 Powering up
while the time remaining for the boot se-
quence counts down in the display.
Line 4 is also used to display plain text status
information (errors, maintenance requests,
function checks or off-spec performance).
If such messages are active, line 4 alternates
between the messages and the parameter
selected for line 4.
Active messages are stored in an internal
buffer. If there is more than one message in
the buffer, the display will cycle through them.
Each message is not just shown in the display
as text, but also indicated by the appropriate
LED on the front panel and the activation of
the appropriate NAMUR relay (if a relay has
been assigned to that NAMUR function;
X-STREAM X2 series instruction manual).
Note!
There are also functions, that do activate a
relay or LED, but are not shown on the display
(e.g. concentration alarms). In such cases,
check the status menu for more information.
CO2.1
O2.2
CO.3
H2.4
MEASUREMENT DISPLAY
X-STREAM X2FD
135.1 ppm
201952 ppm
58.8 ppm
1.5 %
3-13