Dubbing; Dubbing To Or From A Vcr - JVC CU-VH1EXS Instructions Manual

34
EN

Dubbing To Or From A VCR

COMPONENT COMPONENT
Y Y
VIDEO VIDEO
OUT OUT
S2 S2
To S2
S-video cable
(provided)
1 2
A To S-VIDEO* IN or OUT
B Yellow to VIDEO IN or OUT
C White to AUDIO L IN or OUT
D Red to AUDIO R IN or OUT
* Connect when your TV/VCR has an S-VIDEO
IN/OUT connector. In this case, it is not
necessary to connect the yellow video cable.
To use this player as a player
1
Following the illustrations, connect the player
and the VCR. Also refer to page 20.
2
Set the player's Playback Mode Switch to
"VIDEO".
3
Set the Power Switch to "ON" while pressing
down the Lock Button located on the switch.
4
Turn on the VCR's power.
5
Insert the source cassette in the player.
6
Insert the recording cassette in the VCR.
7
Engage the VCR's AUX and Record-Pause modes.
Refer to the instruction manual for the VCR.
Pb Pb Pr Pr
VIDEO VIDEO L L AUDIO AUDIO R R
To AV
Audio/video cable
(provided)
3 4
TV
VCR
8
Press 4/9 on the player to start playback of the
source tape.
9
At the point you want to start dubbing, engage
the VCR's Record mode.
10
To pause dubbing, engage the VCR's Record-
Pause mode and press 4/9 on the player.
11
Repeat steps 8 – 10 for additional editing. Stop
the VCR and player.
NOTES:
It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the
battery pack. ( pg. 12)
As the player starts to play your footage, it will
appear on your TV. This will confirm the
connections and the AUX channel for dubbing
purposes.
Before you start dubbing, make sure that the
indications do not appear on the connected TV. If
they do, they are being recorded onto the new
tape.
To choose whether or not the following displays
appear on the connected TV...
• Date/time
Set "DATE/TIME" to "AUTO", "ON" or "OFF".
( pg. 28, 31) Or, press DISPLAY on the remote
control to turn on/off the date indication.
• Time code
Set "TIME CODE" to "OFF" or "ON".
( pg. 28, 31)
• Indications other than date/time and time code
Set "ON SCREEN" to "OFF", "LCD" or "LCD/
TV". ( pg. 28, 31)
Playback images recorded in HD or SD mode with
this player will be converted to DV format (480i)
image.
To use this player as a recorder
1) Perform steps 1 to 3 in the left column.
2) Set "S/AV INPUT" to "ON". (
3) Set "REC MODE" to "SP" or "LP". (
4) Insert the recording cassette in this player.
5) Press and hold REC (7), then press 4/9 to
engage the Record-Pause mode. The "
indication appears on the screen.
6) Press 4/9 to start recording. The
rotates.
7) Press 8 to stop recording. The
stops rotating.

DUBBING

pg. 28, 29)
pg. 28, 29)
"
A/V in
indication
indication