Advertisement
TROUBLE
The iron is unplugged from mains
power.
The temperature dial has not
Not enough heat.
been rotated from "0" position.
The temperature dial has not
been rotated to desired setting.
The temperature dial has not
Too much heat.
been rotated to desired setting.
The temperature dial has been set
No steam is
to MIN (the temperature is not hot
being produced
enough for producing steam).
or there is a
leakage.
Too little water in water tank.
The (vertical) shot of steam
function has been used too often
within a very short period.
No shot of
steam or no
The iron is not hot enough.
vertical steam.
Too little water in water tank.
The temperature dial is set out
of steam range.
Leaking water
The iron is not hot enough.
from soleplate.
The water tank is filled over
'MAX' level.
The steam control switch is not
in correct position.
Too little steam.
Steam holes are blocked.
Too little water in the water tank.
Not enough pressure, or air
inside the pump.
No water spray.
Too little water in the water tank.
TROUBLESHOOTING
Troubleshoot your problem by using the chart. If the iron still does not operate
correctly, it may be defective.
POSSIBLE CAUSE
© 2015 RVM Australia Pty Ltd. All Rights Reserved
POSSIBLE SOLUTION
Check that the plug is
connected to mains power.
Check that the power switch at
power outlet is on.
Check that the temperature dial
is in correct setting.
Check that the temperature dial
is in correct setting.
Allow the appliance to cool down
after changing the setting from
high to lower temperature.
Set the dial to a higher
temperature setting.
Fill with water per instructions.
Continue ironing in horizontal
position and wait a while before
using the (vertical) shot of steam
function again.
Set the dial to a higher
temperature setting.
Fill with water per instructions.
Set the temperature dial as per
steam range.
Open steam only after the tempera-
ture indicator light goes out.
Pour out the excess water. Use
caution as the water may be hot.
Set the steam control switch to
the correct position.
Clean steam holes using cotton tip,
moistened with distilled water.
Fill with water per instructions.
Block the spray nozzle with
fingertip, and push the spray
button several times continuously.
Fill with water per instructions.
9
Advertisement
