Operating The Dispenser - Rheem XpressHot Getting Started Manual

OPERATING THE DISPENSER

This dispenser is an addition to your existing kitchen faucet. It can
dispense filtered cold and near-boiling hot water. The instructions for
dispensing by water type are below:
FILTERED COLD WATER – Tap the dispense water button to begin the
flow of cold water. Tap again to stop the flow.
NEAR-BOILING HOT WATER – Press the safety lock / unlock button and
immediately press the dispense water button to get near-boiling hot water.
The ring near the dispense button will flash red. Pressing the dispense
button again will stop the flow.
2-1 DISPENSER
Safety Lock/Unlock Button
Spout
Dispense Button
Hot/Cold Indicator Light
BASE UNIT DISPLAY INTERFACE
• The + and – buttons can be used to increase or decrease the
set point temperature. Pressing both buttons simultaneously will
change the display units between Celsius and Fahrenheit.
• You can set a reminder to change your filter from the display interface.
The filter is set at 50 by default, which is about 1,250 gallons (5,000
liters). Based on your water quality, the number can be adjusted up or
down in increments of 10 using the + and – buttons to ensure the filter
is replaced at the optimal frequency. The filter light will turn orange
when the filter has a life of 100 gallons remaining and will turn red
when it needs replaced. Filters set to 98 (max.) will have a life of about
2,500 gallons (10,000 liters).
• Tap the ECO button to set your XpressHot in energy-saving
mode. ECO mode uses a heating algorithm that saves energy
consumption but can potentially reduce the hot water available
marginally at the set temperature.
INTERFACE
O P E R AT I N G I N S T R U C T I O N S 13