JVC GR-DVL167EG Instructions Manual page 34

34
EN
Menu Screen Explanations (cont.)
TELE OFF
MACRO
ON
WIDE OFF
MODE
CINEMA
SQUEEZE
OFF
WIND
CUT
ON
OFF
BEEP
BEEP
MELODY
OFF
TALLY
ON
ID NUMBER
: Factory-preset
NOTES:
The " MANUAL" settings are effective only when the Power Switch is set to "
" SYSTEM" functions which are set when the Power Switch is set to "
Switch is set to "PLAY" (
USING MENUS FOR DETAILED ADJUSTMENT
Usually the distance to a subject where the lens is in focus depends on the
zoom magnification. Unless there is a distance more than 1m to the subject,
the lens is out of focus at the maximum telephoto setting. When set to "ON",
you can shoot a subject as large as possible at a distance of approx. 60 cm.
• Depending on the zoom position, the lens may go out of focus.
Records with no change in the screen ratio. For playback on a TV with a
normal screen ratio.
Inserts black bands at the top and bottom of the screen. During playback on
wide-screen TVs, the black bands at the top and bottom of the screen are cut
and the screen ratio becomes 16:9.
to your wide-screen TV's instruction manual. During playback/recording on 4:3
TVs/LCD monitor/viewfinder, black bands are inserted at the top and bottom of
the screen and the image appears like a letterboxed 16:9 movie.
For playback on TVs with an aspect ratio of 16:9. Naturally expands the image
to fit the screen without distortion.
to your wide-screen TV's instruction manual. During playback/recording on 4:3
TVs/LCD monitor/viewfinder, the image is elongated vertically.
Disengages the function which cuts down on noise created by wind.
Helps cut down on noise created by wind. "
sound will change. This is normal.
Even though not heard while shooting, shutter sound is recorded on the tape.
The beep sounds when the power is turned on or off, and at the beginning and
end of recording. Also to activate the shutter sound effect (
Instead of a beep, a melody sounds when any operation is performed. It also
activates the shutter sound effect (
The tally lamp remains off at all times.
The tally lamp comes on to signal the start of recording.
This number is necessary when connecting the camcorder to a device such as
a computer using the J terminal (JLIP) or PC connector. The numbers range
from 01 to 99. Factory setting is 06.
pg. 36).
appears. When using this mode, refer
appears. When using this mode, refer
" appears. The quality of the
pg. 28).
".
" are also applied when the Power
(cont.)
pg. 28).