Dubbing To Or From A Video Unit Equipped With A Dv Connector - JVC GR-DV2000ED Instructions Manual

Power Switch
To DV
IN/OUT
Core filter
DV cable
(optional)
Core filter
To DV
IN/OUT
Video unit equipped
with DV connector
PLAY (4)
STOP (5)
To Use This Camcorder As A Recorder . . .
1. Turn the Power Switch to "
2. Set "REC MODE" to "SP" or "LP" in the Menu Screen (
3. Connect the DV cable as shown in the illustration and load a cassette to record on.
4. Press the Recording Start/Stop button to engage the Record-Pause mode. "
5. Press the Recording Start/Stop button to start recording.
6. Press the Recording Start/Stop button again to engage the Record-Pause mode.
NOTES:
Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current
"SOUND MODE" setting (
During Digital Dubbing, no signals are output from the AV connector.
Dubbing To Or From A Video Unit Equipped
With A DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any
image or sound deterioration.
[To use this camcorder as a player]
1
2
3
4
NOTES:
It is recommended to use the AC Power Adapter/Charger
as the power supply instead of the battery pack (
If the remote control is used when both the player and
recorder are JVC video units, both units will perform the
same operation. To prevent this from happening, press the
buttons on both units.
For Digital Dubbing, this camcorder can be connected only
to one device at a time. This camcorder can also be used as
a recorder.
If a blank portion or disturbed image is played back on the
player during dubbing, the dubbing may stop so that an
unusual image is not dubbed.
Even though the DV cable is connected correctly, some-
times the image may not appear in step 4. If this occurs, turn
off the power and make connections again.
If "Playback Zoom" (
(
only the original playback image recorded on the tape is
output from the DV IN/OUT connector.
When using a DV cable, be sure to use the optional JVC
VC-VDV204U DV cable.
" while pressing down the Lock Button located on the switch.
pg. 29).
Make sure all units are turned off. Connect the
camcorder to a video unit equipped with a DV input
connector using a DV cable as shown in the illustration.
Set the camcorder's Power Switch to "
pressing down the Lock Button located on the switch,
turn on the video unit's power, and insert the
appropriate cassettes in the camcorder and the video
unit.
Press 4 to play back the source tape.
While watching the playback on the monitor, engage
the DV connector-equipped video unit's record mode
from the spot on the source tape you want to begin
recording.
pg. 63), "Playback Special Effects"
pg. 64) or "Snapshot" is attempted during playback,
pg. 41).
" appears on the screen.
DV. IN
rotates.
59
EN
" while
pg. 9).
stops rotating.