Table of Contents
Advertisement
CAUTION. This packaging contains
sharp objects. Take care when
unpacking. Remove the machine,
together with the accessories supplied, from the
packaging. Check carefully to ensure that the
machine is in good condition and account for all the
accessories listed in this manual. Also make sure
that all the accessories are complete.
PACKING CONTENTS
•
Rotary hammer drill
•
Auxiliary handle
•
Depth stop
•
SDS point chisel bit
•
SDS flat chisel bit
•
SDS drill bits x 3 (8,10,12mm)
•
Carry case
•
Operator's manual.
WARNING. If any parts are damaged or
missing, do not operate this product until
the parts are replaced. Use of this
product with damaged or missing parts
could result in serious personal injury.
WARNING. Do not connect to power
supply until assembly is complete.
Failure to comply could result in
accidental starting and possible serious
personal injury.
WARNING. Do not attempt to modify this
product or create accessories not
recommended for use with this product.
Any such alteration or modification is
misuse and could result in a hazardous
condition leading to possible serious
personal injury.
FITTING SDS BITS
Different drill bits can be used with this product
depending on the workpiece material and
application required.
WARNING. Always use drill bits
according to the intended use. For
example, never use a drill bit intended
for working on wood for working on
stone or vice versa.
Observe the technical requirements of this product
(see section "Specification") when purchasing and
using drill bits.
UNPACKING
If any parts are found to be missing, the machine
and its accessories should be returned together in
their original packaging to the retailer. Do not throw
the packaging away, keep it safe throughout the
guarantee period, then recycle if possible,
otherwise dispose of it by the proper means. Do
not let children play with empty plastic bags due to
the risk of suffocation.
ASSEMBLY
Some drill bits are very sharp and become hot
during use.
Handle them carefully. Wear protective gloves
when handling cuts.
INSERTING SDS BITS
Apply a thin coating of grease to the splined drive
system (SDS) shank of the drill bit.
Insert the bit into the tool. Turn the bit and push it in
until it engages, Fig.1.
After installing, always make sure that the bit is
securely held in place by trying to pull it out.
REMOVING SDS BITS
Pull the locking collar backwards and remove the
SDS drill bit, Fig.2. Insert a new one as described
above, if desired.
7
Fig. 1
Fig. 2
Advertisement
Table of Contents
