Table of Contents
Advertisement
Quick Links
owner's manual
500W Monoblock Subwoofer Amplifier
Thank you for purchasing a Total Mobile Audio amplifier for
your automotive sound system.
Your amplifier has been designed and manufactured to exacting
standards in order to ensure years of musical enjoyment in your vehicle.
For maximum performance and extended warranty
coverage, we highly recommend that you have your new amplifier
installed by an authorized Total Mobile Audio dealer. Your authorized
dealer has the training, expertise and installation equipment to ensure
optimum performance from this product. Should you
decide to install the amplifier yourself, please take the time
to read this manual thoroughly so as to familiarize yourself
with its installation requirements and setup procedures.
If you have any questions regarding the instructions in this
manual or any aspect of your amplifier's operation, please contact your
authorized Total Mobile Audio dealer for assistance. If you need further
assistance, please call our Technical Support Department
at (954) 443-1100 during business hours.
Advertisement
Table of Contents
Related Manuals for JL Audio T2-500.1
Summary of Contents for JL Audio T2-500.1
- Page 1 owner’s manual 500W Monoblock Subwoofer Amplifier Thank you for purchasing a Total Mobile Audio amplifier for your automotive sound system. Your amplifier has been designed and manufactured to exacting standards in order to ensure years of musical enjoyment in your vehicle. For maximum performance and extended warranty coverage, we highly recommend that you have your new amplifier installed by an authorized Total Mobile Audio dealer.
-
Page 2: Protect Your Hearing
(pg. 7) +12dB Input Sens. LP Filter Frequency (Hz) Bass Boost a JL Audio® Company Total Mobile Audio Mounting the amplifier upside down is strongly discouraged. If mounting the amplifier under a seat, make sure there is at least 1 inch (2.5 cm) of space above the amplifier’s outer shell to permit... -
Page 3: Product Description
This step is not optional! to the needs of the system. 2) Run power wire (minimum 4 AWG) 13) Install power wire fuse (60A for a single T2-500.1) from the battery location to the amplifier and reconnect the negative battery post terminal. - Page 4 The low-pass filter in the T2-500.1 is fully variable between 40 Hz and 130 Hz via the “LP Filter Frequency” control knob. The 12 o’clock position corresponds to 80 Hz, and is a good starting point for system tuning.
-
Page 5: Remote Level Control
“PreamP outPuts” remote leVel Control The T2-500.1 incorporates a preamp output The T2-500.1 includes a remote level control section, designed to make multiple amplifier that can be mounted in the front of the vehicle. systems easy to set up. This section consists... - Page 6 3Ω 35.5 V 2Ω 31.5 V Total Mobile Audio aPPendix b: t2-500.1 specifications general specifications: Recommended Fuse Value: 60A Recommended Fuse Type: ANL at battery, 4x 15A ATC fuses on amplifier chassis. input section: Low-Level Input: Single-ended with RCA jacks...
- Page 7 aPPendix C: troublesHooting “How do i properly set the input sensitivity on my amplifier” Please refer to Appendix A (page 12) to set the input sensitivity for maximum, low-distortion output. “my amplifier doesn’t turn on” Check the fuse, not just visually, but with a continuity meter. It is possible for a fuse to have poor internal connections that cannot be found by visual inspection.
- Page 8 Use this diagram to document your amplifier’s switch and control positions. Preamp Amplifier Outputs Inputs Remote LEFT LEFT Level Port Power Reversed | Normal Output Polarity +12dB Input Sens. LP Filter Frequency (Hz) Bass Boost a JL Audio® Company RIGHT RIGHT Total Mobile Audio...
- Page 9 (do not send product for repair to this address) Products purchased outside the United States of America are covered only by that country’s distributor and not by Total Mobile Audio / JL Audio, Inc. Printed in China 9:00 AM – 5:30 PM (Eastern Time Zone) total mobile audio / Jl audio, inc 10369 North Commerce Pkwy.