Table of Contents
Advertisement
Final Drum Assembly Onto Shaft
• Clean and apply blue threadlocker to the ten (10) hex head bolts, then insert each through the
endcap threading into the mandrel. Hand-tighten in a star sequence (see below).
Torque to 65 ft-lbs (requires 3/8" hex bit socket).
Side Plate Installation
• Align hex shaft with sideplate bearing
• Using the handles, lift the sideplate into the main housing – the square notches must align.
NOTE: the weight of the drum can cause the shaft to sag and not align.
a) Raise/lower the machine using the actuator to level the shaft and allow the sideplate on
b) Using a pry bar, pry the sideplate off the floor into the housing
• Insert side plate bolts, tighten using a 9/16" socket. Torque to 40 ft-lbs, do not impact.
A GRACO COMPANY
9
Advertisement
Table of Contents
