Table of Contents
Advertisement
Troubleshooting
Problem
The projector does
not turn on.
No picture.
Image is unstable.
Picture is blurred.
Remote control does
not work correctly.
3D content does not
display correctly
Cause
There is no power from the power
cable.
Attempting to turn the projector on
again during the cooling process.
The lamp cover is not securely
attached.
The video source is not turned on or
connected correctly.
The projector is not correctly
connected to the input source device.
The input source has not been
correctly selected.
The connection cables are not
securely connected to the projector
or the signal source.
The projection lens is not correctly
focused.
The projector and the screen are not
aligned properly.
The lens cover is still closed.
The batteries are out of power.
There is an obstacle between the
remote control and the projector.
You are too far away from the
projector.
The 3D glasses are out of battery.
The settings in the 3D menu are not
set correctly.
Your Blu-ray Disc is not in 3D
format.
The input source has not been
correctly selected.
Remedy
Plug the power cable into the AC inlet on the
rear of the projector, and plug the power
cable into to the power outlet. If the power
outlet has a switch, make sure that it is
switched on.
Wait until the cooling down process has
completed.
Correctly attach the lamp cover.
Turn the video source on and check that the
signal cable is connected correctly.
Check the connection.
Select the correct source with the SOURCE
key on the projector or remote control.
Correctly connect the cables to the
appropriate terminals.
Adjust the focus of the lens using the focus
ring.
Adjust the projection angle and direction as
well as the height of this projector if
necessary.
Remove the lens cover.
Replace both of the batteries with new ones.
Remove the obstacle.
Stand within 8 meters (26.2 feet) of the
projector.
Recharge the 3D glasses.
Correctly set the settings in the 3D menu.
Blu-ray Disc
Use a 3D
Select the correct source with the SOURCE
key on the projector or remote control.
and try again.
Maintenance
55
Advertisement
Table of Contents
