Set Up Operations; Re- Installation - U-Line UCFZ553-SS71A User Manual

The power cord must be rated for the product and for the voltage and current marked
on the product's electrical ratings label. The voltage and current rating of the cord
should be greater than the voltage and current rating marked on the product.
Do not use reductions or multi-way adapters (Fig.1)

It is important to connect the equipment correctly to an efficient earth system
executed in compliance with the relevant legislation.
 The equipment must be positioned so that plug can be easily reached (Fig. 1)
If the SUPPLY CORD is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.

2.4 SET UP OPERATIONS

To avoid errors and accidents, perform a series of checks for possible damage sustained during
transport, installation and hook-up operations before starting up the unit.
PRELIMINARY CHECKS
 Check the condition of the power cord (no cut or chaffing). Check that the door hinges and
shelf support are stable.
 Check the door seals and shelves are not damaged (broken or scratched) and that the door
closes and seals properly.
 Make sure all copper tubing, unions are in perfect condition.
FOR OPTIMAL PERFORMANCE
 Do not block the motor compartment air vents. Do not lay objects on the top of the equipment
Before storing products wait until they are cold.
 Arrange the products on suitable shelves or in containers. Do not place products directly on
the base or against the walls, doors or fixed guards of the unit.
 Make sure doors are kept closed.
 Keep the defrost water drain outlet clear.
 Limit the frequency and duration of opening; each time the door is opened the internal
temperature will alter.
 Load products at ambient temperature gradually to allow correct refrigeration. Perform routine
maintenance regularly.

2.5 RE- INSTALLATION

Observe the following procedure:
Use and Operational Manual
14
OPERATION
Fig. 1
14