Cleaning And Maintenance - Stanley SXCMD15WE Instruction Manual For Owner's Use

and/or in case of problems with the mechanism,
contact the service centre.
– Unwinding the hose: carefully remove the hose
from the housing; after unwinding the necessary
length of hose, loosen the grip slightly, in this way,
when a "CLICK" is heard, the lock is inserted (fig. 9).
Ensure that the hose is locked before releasing
the grip.
– Rewinding the hose: loosen the lock by pulling
the extension hose outwards (fig. 10). Let the hose
rewind in a controlled way, accompanying it until it
completely returns to the reel.
● Insert the power cord plug into a suitable socket, mak-
ing sure that the I/O switch on the compressor is in the
switched off position "O" (OFF).
● At this point the compressor is ready for use.
● Press switch I/O to start the compressor.
● Check that the air consumption and the maximum
operating pressure of the pneumatic tool to be used
are compatible with the pressure set on the pressure
regulator (not included) and with the amount of air
delivered by the compressor.
● At the end of the work:
– rewind the hose completely, putting it in its housing;
– stop the compressor by acting on the I/O switch,
putting it to the switched off position "O" (OFF).
– disconnect the electrical plug.
● If the compressor shall be used again, wait at least 10
seconds from the moment when it switches off before
restarting it.
FUNCTION
Cleaning of intake filter and/or
substitution of filtering element

8. CLEANING AND MAINTENANCE

Pull the power plug before doing any cleaning and
maintenance work on the appliance.
Wait until the compressor has completely cooled
down. Risk of burns!
8.1 Cleaning
● Keep the safety devices free of dirt and dust as far as
possible. Wipe the equipment with a clean cloth or blow
it with compressed air at low pressure.
● We recommend that you clean the appliance immediately
after you use it.
● Do not use cleaning agents or solvents; these may be
aggressive to the plastic parts in the appliance. Ensure
that no water can get into the interior of the appliance.
● You must disconnect any pneumatic tools from the
compressor before cleaning. Do not clean the compressor
with water, solvents or the like.
● Keep the reel hose clean to allow proper sliding.
8.2 Cleaning the intake filter (ref. 1)
The intake filter prevents dust and dirt being drawn in.
It is essential to clean this filter after at least every 100
hours in service. A clogged intake filter will decrease the
compressor's performance dramatically.
The body of the intake filter is irremovable, it MUST
NEVER be removed. To clean or replace the filtering
element, simply remove the cover. To remove the cover,
unscrew counterclockwise.
Clean the filtering element by tapping it to remove the dirt,
blast it down with low-pressure compressed air (approx. 3
bar) and re-insert it.
8.3 Storage
Remove the plug from the socket and vent the
appliance and all compressed air tools connected to
it. Store the compressor in such a way that it cannot
be operated by unauthorized persons.
MAINTENANCE RESUMPTIVE TABLE
AFTER THE FIRST
100 HOURS
●
23
Warning!
Warning!
Warning!
EVERY 100 HOURS
●
G
B