3. Color Reproduction Adjustment
Adjust the color Separation matrix coefficient so that proper color
reproduction is produced.
Subject
Measurement Point
Measuring Instrument
Adjustment Page
Adjustment Address
Specified Value
Adjusting method:
1)
Select page: 0, address: 01, and set data: 01.
2)
Select page: 2, address: 01, set data: 3D, and press the PAUSE
button of the adjustment remote commander.
3)
Select page: F, address: 1A, set data: 3F, and press the PAUSE
button of the adjustment remote commander.
4)
Adjust the GAIN and PHASE of the vectorscope, and adjust
the burst luminance point to the burst position of the color
reproduction frame.
5)
Change the data of page: F, address: 44, 46, AA and AB, and
settle each color luminance point in each color reproduction
frame.
Note: Be sure to press the PAUSE button of the adjustment re-
mote commander before changing the addresses. If not,
the new data will not be written to the memory.
6)
Press the PAUSE button of the adjustment remote com-
mander.
Processing after Completing Adjustments:
1)
Select page: 2, address: 01, and set data: 00, and press the
PAUSE button of the adjustment remote commander.
2)
Select page: 0, address: 01, and set data: 00.
Color bar chart standard picture
frame
Video output terminal
Vectorscope
F
44, 46, AA, AB
All color luminance points should
settle within each color reproduc-
tion frame.
For NTSC model
Y
L
Burst position
For PAL mode
Burst position
Y
L
5-11
R-Y
M
G
R
B
C
Y
G
R-Y
M
G
R
B
G
C
Y
Fig. 5-1-9
B-Y
B-Y