Table of Contents
Advertisement
wrap around the opposite bus wire exiting the other side. Use small pliers
or tweezers to help thread the wire around the bend in the bus wire.
12. Use ample heat to solder the magnet wire to the buss wire.
13. Do the same with the magnet wire exiting the other side. Cross it over
to its opposite side and solder with ample heat.
14. Bend the core back down. It will probably want to spring back up again
but you will have to press down and solder at the same time to make sure
the wire is tight to the board.
15. Solder the bus wires down to the main board's provided pads using
your tweezers or needle nose pliers to press down on the bus wire while
soldering to keep it from springing up.
PM10DC 25
Advertisement
Table of Contents
